Apollo SL Instrukcja Instalacji Strona 17

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 16
Installation
Apollo SL50 / SL60 Installation Manual
9
SECTION 2 - INSTALLATION
This section describes the installation of the SL50 and SL60 including mounting, wiring, and
connections. A post installation check-out procedure is included at the end of this section.
PRE-INSTALLATION INFORMATION
Always follow good avionics installation practices per FAA Advisory Circulars (AC) 43.13-
1A, 43.13-2A, AC 20-138, and AC 20-67B, or later FAA approved revisions of these
documents.
Follow the installation procedure in this section as it is presented for a successful installation.
Read the entire section before beginning the procedure. Perform the post installation check-
out before closing the work area in case problems occur.
INSTALLATION OVERVIEW
A successful installation should start with careful planning including determination of
mounting location for the SL50/60, antenna mounting, connections to microphones, speakers,
and headphones, cable routing, and other required modifications. Once the mounting location
has been determined, prepare the mounting frame for installation. It may be easier to complete
the wiring harness and attach the connectors to the mounting frame before installing the
mounting frame.
INSTALLATION CONSIDERATIONS
MOUNTING CONSIDERATIONS
The SL50/60 is designed to mount in the avionics stack in the aircraft instrument panel within
easy view and reach of the pilot. The standard package includes a mounting frame for ease of
mounting, connections, and service of the unit. Allow an additional one inch clearance to the
rear of the mounting frame for connectors and cables.
For typical installations, the SL50/60 does not require external cooling. When mounting the
unit, leave a clearance of 1/8 to 1/4 inch between avionics to allow for air circulation.
MINIMUM SYSTEM CONFIGURATION
The minimum system configuration and external connections requirements are described in
the System Configurations section on page 4.
HELICOPTER REQUIREMENTS
The SL60 is qualified for helicopter installation with certain mount tube and SL60
configurations (see Section 4 - Limitations).
EQUIPMENT MOUNTING
Once the cable assemblies have been made, attach the 15 and 37 pin d-sub and coaxial cable
connectors to the rear connector mounting plate and the mounting frame as illustrated in Figure 4
and
Przeglądanie stron 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 61 62

Komentarze do niniejszej Instrukcji

Brak uwag