Apollo SL Instrukcja Instalacji Pobierz pdf (Strona 22)

Installation

14 Apollo SL50 / SL60 Installation Manual

When making connections to the SL50/60, use a three conductor shielded cable. Make RxD,

TxD, and signal ground connections to the 37 pin connector. Connect the shield(s) to the rear

of the mounting frame on the connector plate. The shield leads must be < 1.25 inches. See

Figure 5.

Complete serial interface specifications are included in Appendix E.

SIMULATOR SELECT INPUT

The simulator select pin on the 37 pin connector must be connected to ground on pin 25. If

left unconnected, the unit will operate in the built-in simulator mode.

SPEAKER AND HEADPHONE OUTPUTS (SL60 ONLY)

Connect the speaker and headphones to the output pins on the rear connector.

MICROPHONE INPUTS (SL60 ONLY)

Microphone input connections should be made using a twisted pair shielded cable. Attach the

signal ground to the mic ground pin on the rear connector and connect the shield to the rear

connector plate.

TRANSMIT KEY INPUT (SL60 ONLY)

The TxKey input on the rear connector must be pulled low to ground to enable the transmitter.

This input should be connected to a microphone or yoke mounted momentary push button

switch.

INTERCOM SELECTOR SWITCH (SL60 ONLY)

The SL60 includes a voice activated intercom function that can be enabled by an external

control switch. This is an optional connection.

When making connection for the intercom selection, connect the intercom selection input to a

remote mounted normally open switch. A momentary toggle or alternate action switch can be

used. Connect the other terminal of the switch to ground. The intercom function is enabled

when the input is pulled low to ground. The monitor function is inhibited when the intercom

function is selected.

REMOTE FLIP/FLOP INPUT (SL60 ONLY)

The SL60 includes a remote flip/flop input. This is an optional input can be connected to a

remote mounted (such as on the yoke) momentary push button switch which pulls the input

low to ground.

ANTENNA INSTALLATION AND CONNECTIONS

COMM ANTENNA (SL60 ONLY)

The SL60 requires a standard 50W vertically polarized antenna. Follow the antenna

manufacturer’s installation instructions for mounting the antenna.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 61 62

Brak uwag

Apollo SL Instrukcja Instalacji Strona 22